![]() ![]() ![]() This will prevent concerns of the glass breaking and PVC and HDPE are very commonly used in reptile enclosures. then add your temp probe and substrate over it. Since it sounds like your heat pad is inside the enclosure, what I would personally do to avoid the risk of cracking the glass, is get a piece of PVC or HDPE sheeting, cut it to be a little larger than the heat pad and place it underneath the heat pad secure it down on the edges with some aluminum tape used in HVAC systems, it adheres really well, just be sure to clean the glass prior to placing it down. Not only could the animal be cut by the glass if it's cracked by the heat pad but burns could also happen very easily if they lay on the glass. Heat pads on glass are known to cause cracks in the glass, so exposing the glass so the animal can rest on it is always unwise. place the hide back down then check the temps while the hide is still over the spot. My advice is to check the hotspot temps with a temp gun take the animal out of its hide. So, if you use the RHP to create an ambient temp of 82ish and your heat mat to create a hot spot of 89-90 then you have a gradient and a hot spot for digestion.īut, it is VERY important to regulate ALL heat sources with a thermostat. If you have your heat sources regulated by a thermostat you don't need to worry about your snake burrowing and being burned. Should I get a small one or can I use vertical levels (higher slate rock for warm, half-buried cave for cool)?Your heat mat should be providing a hot spot to aid in digestion. I was relying on the heat mat to give him a warm side. However, what I do is just push some substrate away under the hide so the glass is exposed and they have that hot spot to lay on for digestion.Īnd also if so, my rhp is almost the same size as the lid, so it’s not providing a huge range from cool side to warm side. Your snake is unlikely to go sit on a slab of rock unless he’s got a place where he can be sheltered and hidden. Keep in mind that BPs are nocturnal so they aren’t baskers. Should I get a small one or can I use vertical levels (higher slate rock for warm, half-buried cave for cool)?I don’t see why the levels thing wouldn’t work, as long as you got the temps right and have matching hides. Maybe get a piece of slate rock, elevated, to absorb some rhp heat for him to lie on? And if so, what would I set the ambient temperature at?Īnd also if so, my rhp is almost the same size as the lid, so it’s not providing a huge range from cool side to warm side. So! I am wondering if I can get rid of the heat mat altogether, and just heat the cage with the heat panel. I don’t dare turn up the heat in case he does decide to burrow some day. My bp does not burrow, and with the substrate, I don’t think he’s getting much belly heat out of the heat mat. I have a heat mat, set to 90F against the glass, and a RHP set to 80ish (78-82 depending on room temp).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |